The Ultimate Overview to upgrade Toyota 4Runner interior Lights to LEDs


Today I will show you exactly how to replace the interior illumination on a 2014 Toyota 4Runner with extremely power LED replacements light bulbs detailed. These installments are extremely straightforward, it should only take around 15 mins with just standard tools needed. allow's get started.


We'll start with the map lights which you'll require a plastic wedge removal tool for to take the lens off. Simply tear it right into the back of the lens, just pop that off, and you'll get your OEM T10 light bulb, after that you'll take the incredibly power T10 canbus LED bulb, insert it straight right into the housing, making sure you have a wonderful secure fit and afterwards you'll reinstall the factory lens cover back right into area. Before complete, you'll intend to test it to see to it you have actually the bulb placed correctly. Move over the other side, follow the very same steps to complete the map light installation.


Move on to the vanity light area, which comes on when you open the mirrors. So we'll take our plastic wedge removal tool and also work it way back with the lens to tear this off to gain access to the original light bulb. You can pull out, take your information and also Super canbus LED bulb, insert it straight right into the outlet.


And after that we'll reinstall the t10 led canbus outlet back into place as well as test the bulb to ensure that it's functioning appropriately.


For the dome light location, we'll take our plastic removal device as well as work our way with the original lens in between the housing as well as lens to stand out off the clips, which are holding it in place and then once the lens is removed.

We'll remove the factory bulb with our device. While factory bulb is taken out, we'll take LED bulb as well as put straight right into the socket.

Once it's been installed, you'll want to examine it to make certain that it's functioning correctly, and after that we'll reinstall the lens cover to finish the installment.


For the cargo light places, you use your plastic wedge tool as well as insert it right into the side of the housing to dispirit a clip to ensure that it appears of the out of the socket. We'll simply dispirit the clip to pull the housing off the vehicle, make it a little bit much easier to function with. After that they'll see four clips holding on the lens, which we can use the plastic device to kind of work our means around. So we can pop it off simpler.


Once you have actually stood out off the lens, you can take the factory bulb out quickly, take your canbus led light bulb and insert it straight right into the housing. Make sure you have actually the LED beaming the proper method. And also make sure it's safely fastened, test it by connecting it back in so that you have the correct polarity. You'll re-install your lens cover, making certain you break whatever securely in area, placing the housing back in as well as after that move over the various other side, complying with the very same steps to complete the setup of the trunk lights.


For the four-door light areas, we'll take our plastic wedge tool and insert it on the side of the housing to dispirit a clip to ensure that we get the setting up off the car. We'll draw the housing down, dispirit this clip to take the assembly off the car totally. We'll push back on the housing to make sure that we can remove this lens setting up, take the OEM light bulb out, take our LED replacement bulb, insert it directly into the housing, re-install the lens cover back on, make certain you break whatever back in position, then you'll reinstall the assembly back onto the factory connector, install it back onto the automobile, examination it to ensure it's functioning appropriately and afterwards we'll put it back on the automobile, break it into area. Follow the very same procedure for all four doors to finish the LED setup.

While all point total, you'll have far more useful output in the cabin in the evening along with a great awesome light appearance. Installment just took about 20 minutes for the whole car with just a plastic wedge device called for, extremely easy?